For example, if you are running a serial version of APCs PowerChute software, the APC UPS service must be stopped prior to running the terminal program.Once the cards have been configured with an IP address, Subnet Mask, and Default Gateway the cards can be accessed, managed, and controlled from other computers on the network.
Apc Network Management Card Device Ip Configuration Wizard Serial Version Of![]() Resolution Network Management Card 1: In regards to Network Management Card 1 (AP9617, AP9618, AP9619) or devices with an embedded Network Management Card 1 (such as a AP78XX or AP79XX Rack PDU, Environmental Monitoring Unit, etc), there are three available options to configure the Network Management Card (NMC) with its initial settings: the Wizard, terminal emulation (localdirect connection), and Address Resolution Protocol (ARP). Default boot mode: DHCPBootP - With DHCP Option 43 Vendor Cookie required to accept DHCP Offer. By default, all of APCs Network Management Card 1 based devices are configured for a boot mode of DHCPBOOTP. If using DHCP, a vendor cookie (DHCP Option 43) is required by default. If it is not configured on your DHCP server, the card will not accept an IP address. ![]() Network Management Card 23 Default boot mode: DHCP Only - With DHCP Option 43 Vendor Cookie NOT required to accept DHCP Offer. By default, all of APCs Network Management Card 2 and 3 based devices (such as an AP8XXX Next Gen Rack PDU (NMC2 only)) with AOS 5.1.1 or higher, are configured for DHCP Only with no vendor cookie required by default. They will obtain an IP address automatically so you may need to refer to your DHCP server to find out what IP address it obtained. All APC devices have a MAC address that begin with 00 C0 B7 which may help while reviewing your DHCP Client List. In order to configure your Network Management Card-enabled device, select one of the available configuration methods listed below. Apc Network Management Card Device Ip Configuration Wizard Download From TheThe Wizard is included on the CD bundled with the cards, and available to download from the APC website. This utility supports NMC1NMC2 cards that have firmware version 3.x.x or higher. Please keep in mind that with certain firmware releases, the NMC can obtain a DHCP address and also prevent the wizard from working correctly. You may want to check your DHCP client list for any MAC addresses beginning with 00 C0 B7, which indicates an APC address. Any card with valid IP settings will have a solid green status LED. If using the wizard over the network, please note, the previously unconfigured NMC must be on the same subnet as the computer running the wizard. ![]() Ultimately, your computer and the NMC will be on a peer to peer network which will allow for configuration as well. NOTE: This wizard will also not work with any Network Management Card family if the NMC was previously configured and not in DHCP or BOOTP boot mode. IP range. NOTE: The Device IP Configuration Wizard is not able to assign the IP address, subnet mask and default gateway settings of Network Management Cards running AOS 6.5.0 and 6.5.2. This is a known issue and has been resolved with AOS 6.5.6. NOTE: In NMC2 firmware version 6.8.0 and higher, and in NMC3, you cannot search for assigned devices already on the network using an IP range unless you enable SNMPv1 and set the Community Name to public. Return to Top Configuration Option 2 - Terminal Emulation (localdirect connection) Terminal Emulation is a built-in function on most operating systems (ex: HyperTerminal). Before using any terminal emulation program, any services using the COM ports must be stopped.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |